产品中心

1、“SPA”键：开关机键，在开机状态下按下此键，控制器关机，在关机状态下按下此键，控制器开机，同时点亮面板开/关机指示灯（款3），初始状态，低风，定时关30分钟；
2、“O3”键：臭氧建，在开机或关机按下此键，实现臭氧的开启或关闭，臭氧每次开启最长为20分钟，关机时同时关闭臭氧功能，臭氧指示灯 对应于臭氧的工作状态；
3、“负离子”键：在开机状态下按下此键，开启或者关闭负离子功能，负离子指示灯 对应于负离子工作状态；
4、“定时”键：在开机状态下按下此键，进入或者退出定时状态，进入定时状态时，初始状态为定时关30分钟；
5、“超声波”键：在开机状态下按下此键，进入或者退出超声波功能，超声波功能：调整风速为第二档，当退出超声波功能时，超声波指示灯 对应于超声波的状态；
6、显示面板“ ”、“ ”：向上及向下键，在定时时间调整状态下，向上或向下键是调整定时时间，不在定时时间调整状态下，向上或向下键为风速调整键，实现风速的增加或者减小，当调整温度时，向上或者向下为调整设定温度（设定温度范围36~46℃，默认温度为42℃）；
7、暖风键，
A、风速只有在2档以上，才允许开启加热；
B、暖风指示灯 对应于加热继电器状态，加热继电器吸合则点亮，加热继电器断开则熄灭；
C、在开机状态下，长按暖风键进入温度设定状态。
8、遥控器森林功能：风速为2档，强制负离子开启；
9、遥控器温泉功能：开启加热，风速为3档；
10、遥控器按键功能与显示面板按键功能类似，但将风速和定时调整分开，分别用“风速+”“风速-”调整风速大小，“定时+”“定时-”调整定时分钟数据，温度调整时，采用“风速+”“风速-”调整设定温度；

1. "Spa" key: on / off key. Press this key in the power on state to turn off the controller. Press this key in the power off state to turn on the controller and turn on the panel on / off indicator (model 3). In the initial state, low wind, turn it off regularly for 30 minutes;
2. "O3" key: when ozone is built, press this key during startup or shutdown to turn on or off ozone. The maximum time for ozone to turn on is 20 minutes. When shutdown, turn off the ozone function at the same time, and the ozone indicator light corresponds to the working state of ozone;
3. "Negative ion" key: press this key in the power on state to turn on or off the negative ion function, and the negative ion indicator light corresponds to the negative ion working state;
4. "Timing" key: press this key in the startup state to enter or exit the timing state. When entering the timing state, the initial state is timed off for 30 minutes;
5. "Ultrasonic" key: press this key in the startup state to enter or exit the ultrasonic function. Ultrasonic function: adjust the wind speed to the second gear. When exiting the ultrasonic function, the ultrasonic indicator light corresponds to the ultrasonic state;
6. Display panel "", "": up and down keys. In the timing time adjustment state, the up or down key is to adjust the timing time. Not in the timing time adjustment state, the up or down key is the wind speed adjustment key to increase or decrease the wind speed. When adjusting the temperature, Up or down is to adjust the set temperature (the set temperature range is 36 ~ 46 ℃, and the default temperature is 42 ℃);
7. Warm air key,
A. The heating can only be started when the wind speed is above gear 2;
B. If the heating relay is on, the heating relay will turn off and the heating indicator will turn off;
C. In the startup state, long press the warm air key to enter the temperature setting state.
8. Forest function of remote control: the wind speed is 2, and the negative ions are forced to turn on;
9. Remote control hot spring function: turn on heating, and the wind speed is 3 gears;
10. The function of the remote control button is similar to that of the display panel button, but the wind speed and timing adjustment are separated. Adjust the wind speed with "wind speed +" wind speed - "respectively," timing + "timing -" adjust the timing minute data. When adjusting the temperature, adjust the set temperature with "wind speed +" wind speed - ";